(b) Disconnect the P34 receiver connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK TRANSMITTER ID
(a) Turn the engine switch off.
(b) Connect Techstream to the DLC3.
(c) Turn the engine switch on (IG) and turn the tester on.
(d) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
(e) Check the values by referring to the table below.
No comments:
Post a Comment