NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR
(a) Disconnect the G16 multi-display controller sub-assembly connector.
(b) Disconnect the G6 display and navigation module display connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. REPLACE MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY
(a) Replace the multi-display controller sub-assembly See: Accessories and Optional Equipment/Entertainment Systems/Entertainment
System Control Module/Service and Repair/Rear Seat Entertainment ECU/Removal.
(b) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(c) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY See: Accessories and Optional Equipment/Navigation
System/Service and Repair/Navigation Receiver (for HDD)/Removal
No comments:
Post a Comment